communication & wireless development tools  (1.156 artikelen gevonden)

The Power Integrations 200 watt 3 phase inverter uses bridge switch BLDC motor driver IC BRD1263C and link switch-TN2 LNK3204D with in field oriented control operation. Link switch device supplies ...

The Power Integrations 300 watt 3-phase inverter used for thermally challenged applications using bridge switch BLDC motor driver IC BRD1265C and link switch-TN2 LNK3204D with in field oriented ope...

The FT900 32-bit microcontroller module, MM900EV-Lite (RS ; 901-5098 901-5098 ) matches the form-factor of the controller board and just plugs straight in. EVE FT812 Display Module. The ME812A-WH50...

The Power Integrations RDK-851 describing a 3-phase inverter reference design board based on the BridgeSwitch motor driver IC that targets high-voltage BLDC fan applications. The inverter board dri...

300mm of K-type thermocouple wire with 482°C rated insulation. Pmod TC1 K-Type Thermocouple. The Pmod TC1 (Revision A) is a cold-junction thermocouple-to-digital converter module designed for a K-T...

Its heart is a dual channel H-bridge driver chip that can handle current up to 2A per channel, controlled by an Atmel ATmega8L which handles the I2C communication with for example an Arduino. Both ...

The Maxim Integrated peripheral module (Pmod) for MAX31865 provides the necessary hardware to interface the MAX31865 RTD-to-digital converter to any system that utilizes Pmod-compatible expansion p...

The MikroElektronika DAC 6 Click is a compact add-on board that contains a fully-featured, general-purpose voltage-output digital-to-analogue converter. It uses the 3-wire SPI serial interface for ...

Thermostat 2 click is a general-purpose thermostat Click board™ designed to be used with any temperature sensor based on the DS1820 sensor design: 3-pin package with 1-Wire® communication interface...

Click board comes with the header strips soldered. TILT-n-SHAKE click mikroBUS™. The Click accessory modules plug into the mikroBUS sockets in MikroElektronika microcontroller development boards. T...

Accessory Category = Communication For Use With = Rock Pi N10 Variants

Accessory Category = Communication For Use With = Rock Pi N10 Variants

ETSI. Antenna with SMA connector. Factory default settings: Rx / Tx addresses: 7F7F7F, Carrier: 869.45MHz (Channel 2), Tx Power: +20dBm, Data Rate: 19.2kbps. RADIOPi Modem Dongle for Raspberry Pi. ...

Accessory Category = Communication For Use With = ROCK 3A, ROCK 5A, ROCK 5B

Supplied with: Arduino Expansion Shield for Raspberry Pi B+ x1 20 cm micro USB cable x1 CR1220 button cell x1. DFRobot Arduino Shield for Raspberry Pi. This shield board from DFRobot is designed to...