development tools  (9.981 artikelen gevonden)

The SEGGER J-Link Signal Smoothing Adapter can be inserted between the J-Link debug probe and the debug target to overcome signal integrity issues. Depending on target load capacitance, signals mig...

J-Link ARM7/9/11 14-Pin Adapter. The J-Link 14-Pin Adapter allows J-Link to work with ARM7/9/11 target processors. It is not needed with most new evaluation boards. Supported Probes. • J-Link BASE ...

J-Link 10-Pin Needle Adapter. The J-Link 10-pin Needle Adapter has been designed to connect a J-Link Probe to a PCB which does not have a mating connector or programming header. Compatible Probes. ...

Classification = Development Board Kit Name = ESP32-DEV-BD38 Technology = Bluetooth, Wi-Fi Device Core = ESP32 Processor Family Name = ESP32

The SEGGER J-Link SiLabs C2 Adapter converts the 20-pin, 0.1 inch pitch standard J-Link connector to a 10-pin, 0.1 inch pitch SiLabs C2 connector.Includes 10 pin ribbon cable

The SEGGER NAND-Flash EVAL evaluation board is an easy to use and cost effective testing tool designed to permit the evaluation of the features and the performance of the emFile NAND driver with va...

The SEGGER J-Link RX FINE Adapter converts the 20-pin, 0.1 inch standard connector to a 14-pin, 0.1 inch RX FINE connector. Includes the necessary cable.Package includes: .1″ 14-pin ribbon cable (1...

Classification = Relay Module Kit Classification = Module For Use With = Arduino, Raspberry Pi Featured Device = Relay Control Card Kit Name = ESP32-RELAY01

SEGGER Microcontroller AdapterThe SEGGER Microcontroller adapter is J-Trace MICTOR 38 adapter that connects to the 38-pin MICTOR connector. It connects the GND, JTAG and some trace pins to their co...

Semtech offers wireless power transmitter and receiver platforms for both direct and indirect charge applications in both standards compliant and non-compliant systems. Semtech is a member of the W...

The SEGGER Intel FPGA Adapter (formerly J-Link Altera Adapter) connects to the 10-pin 100-mil Intel FPGA JTAG connector providing debug access to FPGA based MCU cores like the dual-core ARM Cortex-...

Classification = Development Board For Use With = Arduino Featured Device = Relay Control Card Kit Name = ESPDUINO-32MHz

J-Link ARM SWD Isolator Board. The J-Link SWD Isolator can be connected between a J-Link Probe and an ARM-board with a 20-pin debug connector to provide electrical isolation. This is essential when...

The SHT3x humidity sensor series consists of a low-cost version with the SHT30 humidity sensor, a standard version with the SHT31 humidity sensor, and a high-end version with the SHT35 humidity sen...

The SEGGER Adapts from the standard J-Link 20-pin 0.1″ target connector to Xilinx 14-pin 2 mm connector (comp. Platform Cable USB II).Package includes: 14-pin 2mm ribbon cable